TOR
Automatic Roof Draining Valve Type:TOR
ECO-VALVE model TOR
Normally open specific gravity sensitive valve,
which closes when the stored product penetrates the
floating roof drain pipe inside the tank.
It is commonly used as a safety requirement
for the draining of rainwater from floating roofs
of petroleum product storage tanks.
In the event of storage product ingress into the drain tubing,
the TOR Valve will sense the presence of the product
and will immediately shut off,
preventing product loss and spillage.
When the TOR closes, the factory fitted switch
can immediately send a feedback signal
to a remote valve position monitoring system,
alerting the relevant authority and enabling prompt action.
Demonstration
FEATURES & BENEFITS
-
High accuracy
-
Integral Strainer
-
Rapid reaction
-
Very low maintenance
-
No external power supply needed
-
Open / Closed Position Indicator / Alarm
-
Integral Automatic Air Vent / Air Eliminator
-
All internals made of stainless steel.
-
Limit Switch: Atex or Nema
-
Div. 1/Zone 1 hazardous areas approved
QUICK FACTS
-
Introduced to the industry in 1997 the TOR is a time proven product.
-
In use in over 20 countries worldwide
and backed by the Global Service Network of ECO-VALVES.
-
The ECO-VALVES model TOR uses a simple reliable principle.
With a straightforward and compact construction It is designed
for minimum maintenance, and to last the lifetime of the tank.
-
Each valve is assembled and fully tested
at the ECO-VALVES ISO 9001 certified manufacturing plant.
FACTORY FITTED OPTIONS
-
Limit Switch: Atex or Nema
Div. 1/Zone 1 hazardous areas approved
-
Crude Oil Compatibility
Measurements
Measurements
1250 mm x 630 mm x 518 mm
49.2 in x 24.8 in x 20.4 in
Basic Installation instruction:
-
In a vertical position (to be performed using a level measuring device to ensure accuracy)
-
Firmly positioned and held securely
-
As close to the storage tank as possible
-
Drainage from the “S” tube is to the ground. If the drainage is to be channeled by a pipe
to a drain, ensure that there is an air gap between the end of the “S” tube and the drainpipe. -
A By-Pass Valve, (not provided) must be installed.